PASLODE PNEUMATIC TOOL F
NS
-200
The pneumatic flooring tool FNS-200 is a tool specially developed for the installation
standard 3/4" to 1/2" hardwood flooring. It has been designed for easy maintenance
where major components can be easily accessed. It makes the installation of hardwood
floor very easy, allowing the operator to set and fasten the boards in the standing
position.
The
FNS-200
nailer/stapler takes both standard L-type 16GA flooring nails and ½"
crown 15½GA flooring staples.
Read these instructions carefully before operating the tool. It is important to understand
warnings/cautions and the safety measures to ensure safe use of the tool.
Technical support, information & schematics can be found at www.paslode.ca
SAFETY MEASURES
These important guidelines should always be followed to work safely with the pneumatic
tool model F
NS
-200:
• Read these instructions thoroughly before using this tool and keep it handy for reference
if necessary.
• Always keep hands, feet or other body parts away from the fastener ejection area.
• Never aim the tool in any direction other than the working area.
• Always carry or manipulate the tool by its handle while the air supply hose is connected.
• Never hit the head cap of the actuator if the plastic base is not sitting perfectly on the
working surface.
• Never leave the tool laying down on its side while the air supply hose is connected; the
tool should always be left on the floor, standing on its plastic base.
• Always disconnect the air supply hose when the tool is not in use or when moving to
another work area.
• Never service or repair the tool, clear obstructions or make adjustments while the air
supply hose is connected.
• Only compressed air should be used to power this tool; do not exceed 110 psi (7.6 bar).
• Never use oxygen or any other compressed gas as a power source for this tool.
Explosion may occur.
• Always wear OSHA-required Z-87 safety glasses with side shields.
• Always wear proper ear and foots protection while the air supply hose is connected.
• Always remove fasteners from the magazine before servicing tool.