A.) FUEL TANK
FLUSH EVERY 200 HOURS OF
OPERATION OR AS NEEDED (SEE
STORAGE, PAGE 10)
B.) UPPER SHELL REMOVAL
-Remove Screw that secure Side Cover as
shown in Figure 13.
-Push out for arrow direction and extract Side
Cover's Bracket from Rectancle Hole and
Separate Side Cover(R).
-Side Cover(L) in opposite of Side Cover(R)
Separates by same method.
(IH125000/IH170000 Models Only.)
-Remove 4 Screws along each side of heater
using medium phillips screwdriver. These
Screws attach Upper Rear and Lower shells
together. (See Figure 13)
(IH75000 Model Only.)
-Remove Screws along each side of heater
using medium phillips screwdriver. These
Screws attach Upper and Lower shells
together.
C.) AIR OUTPUT, AIR INTAKE AND
LINT FILTERS WASH AND DRY
WITH SOAP AND WATER OR
REPLACE EVERY 500 HOURS OF
OPERATION OR ONCE A YEAR.
-Remove Upper Shell.(See Figure 13)
-Remove Fan guard.(See Figure 14)
-Remove End Filter Cover Screws using
medium phillips screwdriver.
-Remove End Filter Cover.
-Replace Air Output and Lint Filters.
-Wash or Replace Air Intake Filter.
-Reinstall Fan Guard and Upper Shell.
11
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
9. MAINTENANCE
WARNING!! : NEVER SERVICE HEATER WHILE IT IS PLUGGED IN OR
WHILE HOT!
USE ORIGINAL EQUIPMENT REPLACEMENT PARTS. Use of third party or
other alternate components will void warranty and may cause unsafe operating
conditions.
Figure 13. Upper Shell Removal.
Figure 14. Air Output,Intake,and Lint Filters
Screw
Upper Shell
Side Cover
Bracket
Hole
Rectangle
Screw
Side Cover(R)
Lint Filter
Screw
End Filter Cover.
Intake Filter
Fan Guard