®
I n s t r u c t i o n M a n u a l
0 1 2- 1 2 23 2 B
Exercise Heart Rate Sensor
PS-2129A
*012-12232*
Equipment
Introduction
The Exercise Heart Rate Sensor uses a transmitter
mounted on a transmitter strap and a receiver inside the
sensor to measure heart rates from 40 to 240 beats per
minute. The sensor can measure the heart rate during
exercise without a sensor cable getting in the way
because the transmitter and the receiver communicate
wirelessly.
The transmitter snaps onto the transmitter strap and the
strap wraps around your chest with the transmitter
positioned over the cardiac muscle. The transmitter
sends the electrical signals from your heart to the
Exercise Heart Rate Sensor. The Exercise Heart Rate
Sensor averages the heart rate in five second intervals. A
small red light-emitting diode (LED) on the sensor blinks
when a heart beat is detected.
The transmitter comes with a replaceable type CR 2505
battery that has an estimated life of two years (assuming
Red LED
Transmitter
Sensor
Transmitter Strap
Connector Snaps
Strap
Adjuster
Electrodes
(not shown)
Strap
Hook
Included
Part Number
Exercise Heart Rate Sensor
PS-2129A
Polar® WearLink® Set (M-XXL)
PS-2524
Also Required
PASCO Interface
see catalog or web site
PASCO Data Collection Software
see catalog or web site
Recommended
Part Number
PASPORT Extension Cable
PS-2500
Accessory
Part Number
Polar® WearLink® strap (XS-S)
PS-2519
For Educational Use Only! Note: This is not a medical device. It is designed for educational use only and should
not be used in any medical process such as life support or patient diagnosis. It is also not intended for use in
graduate research or industry including industrial control or any type of industrial testing.