![background image](http://html1.mh-extra.com/html/pasco/me-9447b/me-9447b_product-manual_3879078005.webp)
Attach the Pulleys
1. Move the pulley yoke to the lower position on the clamp:
a. Unscrew the thumbscrews on both sides of the clamp.
b. Align the holes in the yoke with the lower clamp holes.
c. Insert the and turn each thumbscrew until finger tight.
2. Place the pulley at the end of the table. Gently turn the clamp thumbscrew to secure
the pulley.
3. Repeat for the other two pulleys.
Attach the Threads
1. Cut three 30 cm pieces of thread.
2. Insert each thread individually through the String Tie hole. Pull the ends of each
string through the hole.
3. Tie the ends of the threads together with an overhand knot so that the threads cannot
be pulled back through the hole.
4. Attach a mass to one thread and run the thread over a pulley. Repeat for the other
two threads.
create
NOTE:
Do not attach more than 200 g to each thread.
5. Adjust the height of each pulley so that the thread is parallel with the table.
Product Guide | 012-13471B
5