Shaking Tower Kit
ME
-
7018
10
012
-
16515A
Part Two: Assemble the Damping Pendulum
Step One: Put the end of the
Medium Axle through the cen
-
ter hole of a Flat Round Con
-
nector. Put the following
components onto the Medium
Axle in the following order.
Note the orientation of the
Tire/Wheel and the Full
Round Connector as shown.
Push the Axle so that the
other end goes through the
center hole of the other Flat
Round Connect.
•
First, put the Nylon
Spacer onto the Axle.
•
Second, put the
Tire/Wheel on the Axle
with the Wheel “hub” pointing as shown in the diagram.
•
Third, put the Full Round Connector on the Axle with the “right angle” part pointing as shown in the diagram.
Step Two: Assemble the Pen
-
dulum and attach it to the Axle.
Attach a Flat Round Connector
to one end of a #4 I-Beam. Add
a 20 Gram Mass to the Flat
Round Connector on both sides
of the #4 I-Beam as shown.
Position the pendulum through
the hole in the middle of the
Fifth Floor. Attach the upper end
of the #4 I-Beam to a bottom
vertical slot on the Full Round
Connector.
Medium
Axle
Nylon
Spacer
Tire/Wheel
Full Round
Connector
Third Hole
of Axle
NOTE: In this diagram,
the Tire/Wheel and one of
the Half Round
Connectors are not shown
so that the Pendulum is
easier to see.
20 Gram Mass
20 Gram Mass
#4 I-Beam
Full Round
Connector
Fifth Floor
Structure
Floor
