Partner K950 CHAIN, Руководство по ремонту

Страница: 15 / 18

BAR ATTACHMENT 9
14
Bar attachment
Removal
Remove the two screws as in
the picture.
Bar attachment
This is removed to:
– Access the pipe/duct that supplies
water to the bar.
– Replace the counterhold/wear
protector
– Replace the splash guard
Removal
Remove the two screws as in the
picture.
Water duct
The marked screw keeps the pipe in
place. Remove it.
Twist the pipe and pull it out of the
bar attachment.
The easiest way to clean a blocked
water duct is with compressed air
(use protective goggles) or with steel
wire.
Water duct
Remove the marked screw
that secures the pipe.
Twist the pipe and pull it out
of the bar attachment.
The easiest way to clean a
blocked water duct is with
compressed air (use protective
goggles) or with steel wire.
Splash guard
This is removed by pressing out
the two attachment points with a
mandrel.
The rear attachment point is turned
up using a screwdriver.
Splash guard
Press out the two attachment
points with a mandrel.
The rear attachment point is
turned up using a screwdriver.
Wear protector/counterhold
Picture on the left: turn up the two
attachments.
Middle picture: when replacing the
wear protector, the simplest way is to
cut the upper and lower attachments
with a pair of pliers.
Fit as in the picture on the right.
First fit the wear protector in the
middle of the bar attachment.
Pull in the outer attachment points
with a pair of pliers. A little grease
makes fitting easier.
Wear protector/counterhold
Picture on the left: turn up
the two attachments.
Middle picture: when re-
placing the wear protector,
cut the upper and lower
attachments.
Picture on the right.
First fit the wear protector in
the middle.
Pull in the outer attach-
ment points with a pair of
pliers. Grease makes fitting
easier.