7300w² Monitor Instruction Manual
3 Safety Precautions
3.1 General
Read the safety precautions carefully.
Check the delivery of your 7300w² Monitor for damage. Any damage should be reported to your supplier as
soon as possible.
Use care when unpacking the monitor.
NEVER
use sharp instruments to open the packaging, as this can
cause damage to the membrane keyboard or display.
Only use sensors and accessories specifically manufactured by Partech for use with this monitor.
Read the operating instructions carefully before installing and operating this monitor.
Keep sharp instruments away from the keypad or display.
Keep the monitor dry and free from dust contamination during installation.
Keep the monitor out of direct sunlight and away from other heat sources.
Keep the monitor away from any other equipment that may radiate electromagnetic influences.
Keep the monitor and cabling away from high voltage cables.
3.2 Electrical Installation
Only suitably qualified personnel may install, operate or repair this equipment. The installer must ensure all
electrical installations comply with local wiring regulations and standards (refer to BS7671 for UK
installations).
Please check the correct voltage is applied to the monitor before making live. Incorrect supply voltage can
cause damage to the 7300w² Monitor.
Only connect sensors from the w² range to this monitor, other Partech products without the w² reference are
not compatible and may cause damage if connected. IF IN DOUBT, PLEASE ASK.
Never work on a live monitor. High Voltages may be present on the circuit boards.
Beware, even when the monitor is electrically isolated from the supply, there is still the possibility of live
voltage on the telemetry terminals from the end user (relay outputs). Please ensure the end user has isolated
any telemetry voltages before undertaking any work or testing.
3.3 Operating
The users must acquire the appropriate knowledge to use the equipment in their specific application, as this
monitor can be used for a wide range of applications.
Partech are always available to provide advice and assistance with your application. Please contact Partech
for further information.
Sensors attached to this monitor must be correctly calibrated. Please follow the procedures for installation
and calibration as provided in the instruction manual for your Partech sensor.
224081IM Issue 22 Issue Date 27/03/2018
`
Page 7 of 46