Bloodhound Installation Instructions
Page 5 of 21
Step 2: Strap the battery pack down to the base plate (optional).
A.
This step is only required if you are using the 54K battery pack.
B.
If the 24” hook
-and-
loop strap and 24” cable tie are not installed in the base plate,
guide the cable
tie through the back pair of slots and the hook-and-loops strap through the front pair of straps.
You may need to bend the tip of the cable tie.
C.
Place the battery pack inside the case and strap it down to the base plate with the hook-and-loop
strap and cable tie, as shown in Figure 3.
Ensure that the display on top of the battery pack and
the charging port on the side of the battery pack are not covered, as shown in Figure 3.
D.
Cut the excess cable tie length.
Figure 2: Strap the battery pack down to the base plate.
Figure 3: Ensure that the battery display and charging port are not covered by the cable tie.
