Distributing International, Inc.
www.NiceStuffOnline.com
[email protected]
34 SOUTH FEDERAL HIGHWAY, SUITE A
DANIA BEACH, FL 33004
Tel. (954)929-2524 Fax (954)929-2455
- You will need to connect these three colored wires to an adapter SPEAKER - LINE.
These colored wires will need to be plugged behind your radio into the line plugs. They
will therefore need this adapter that you can find in electronics stores, i.e. Radio Shack.
- Once you have the adapter, you will have to plug the red wire into the line plug +, the
white wire into the line plug -, and the blue wire into the Mute input of the radio. The
other side of the single black cable needs to be plugged into the control box of the kit.
6. ADDITIONAL TIPS
6.1. Mute Issues
6.1.1.
Mute Polarity
A ground signal is needed to operate the mute (not a12V).
6.1.2.
Radio without a mute
If there is no mute input on the car radio, use a small relay to break the
connection and disconnect the ignition input to the radio (and the CD).
You may have a cycling on the antenna due to the power loss, but you can
also avoid it by using a slightly more complex relay.
6.1.3.
No sound out
Please check the mute cable connections. The "mute cable" should not be
connected to the rear speakers. The sound of the phone conversation is
muted on the rear speakers and is sent only on the front speakers.
