Parrot CK 3000 Evolution Скачать руководство пользователя страница 2

 

                             

Distributing International, Inc.

 

               

 
         

www.NiceStuffOnline.com 
[email protected]         

 

 

 

34 SOUTH FEDERAL HIGHWAY, SUITE A 

DANIA BEACH, FL 33004 

Tel. (954)929-2524        Fax (954)929-2455 

 

Parrot CK3000 Evolution kit contains: 

- Electronic control box 
- Microphone 

- Keypad with a green “On” button,  red “Off” button and a Volume/Menu Access                               
Scroll Wheel 

- ISO car radio harnesses (2) 
- Manual 

Parrot CK3100 adds LCD display instead of Keypad 
Parrot CK3300 adds GPS receiver antenna 
 

Electronic control box

  

Try to mount the control box in an accessible location, away from HVAC unit. Do not 
install the control box close to the heater or to the air-conditioning system. 
 
Protect the control box from direct sunlight. Avoid installing the box inside of a metal 
enclosure, such as a glove compartment. (This will adversely affect the quality of the 
Bluetooth connection.)  
 

Microphone

  

The microphone should be directed towards the driver, and should preferably be installed 
between the visor and rear-view mirror. The distance between the microphone and the 
user should be between 16 and 20 inches. Make sure no ventilation duct is pointed into 
the microphone. 

 
Keypad/LCD 

Installation of the Keypad or LCD Display should be in an easily accessible place, on a 
clean, flat surface. Connect the Keypad or LCD to the connector of the mute cable. Install 
LCD away from direct sunlight. 

 
Mute cable and Power cable

The power cable is identified by its two gray ISO connectors with the notch located on 
the side. 
The mute cable is identified by its two black ISO connectors with the notch located in the 
middle. 

 
 
IMPORTANT

 (CK3100/CK3300 only). Properly installed kit must say Good Bye on 

LCD and stay On for another minute or so after the car is turned off. If that does not 
happen and the kit shuts off at once, invert the Orange (Ignition) and Red (Battery) wires, 
by removing fuses and switching wires. That should fix the problem. 

 
 
 

Содержание CK 3000 Evolution









Отзывы: