F62
27
Installation & Operating Instructions for the
Parrotuncle Owner’s Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Parrotuncle Lighting, 218 Black Tie Lane, Chapel Hill, NC
www.parrotuncle.com
Parrot Uncle YOU CAN BE SURE OF are trademarks of Eileen Grays LLC.
Used under license by Eileen Grays LLC.
All rights reserved.
Made in
CHINA
FAN INSTALLATION INSTRUCTIONS
WARNING
Make sure electricity is turned off at the main power box before commencing work. Turn off the power by removing fuse or turning off circuit breaker before installing the fan and replacing the lamps.
• The lowest point on the fan blade must be at least 2.1 metres (7 feet) from the floor.
• Make sure that ceiling joists are strong enough and of adequate size to support the weight of the fan of about 35 kg.
Rotate 4* E12 bulbs (not included) into the lamp holders ,
The
crystal shade light kit was pre-installed.
Step 1 Install Mounting Bracket
Ceiling Canopy Mounting Screw
Install the mounting bracket onto the electrical
junction box in the ceiling using two machine
screws, two washers and two lock washers
(see
figure 1)
.
The mounting bracket has slotted holes to enable
it to move sideways for proper alignment. Make
sure the mounting bracket is centered over the
electrical junction box and that it is securely
attached
(see figure 2)
.
Loosen the two canopy mounting screws on the
downside face of the mounting bracket. Back
them out about half way. This will allow for easier
installation of the ceiling canopy later
(see figure
3)
.
Fig. 1
Slotted Holes
Junction Box
NO MOVEMENT SHOULD OCCUR BETWEEN
THE MOUNTING BRACKET AND THE ELEC-
TRICAL JUNCTION BOX.
Pull the electrical wires in the junction box down
and through the mounting bracket.
Fig. 2
Fig. 3
