Parrot Uncle BBLDA158A, Инструкция по установке и эксплуатации

Страница: 5 / 41

WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
BBLDA158A
Installation & Operating Instructions for the
Parrot Uncle Owner's Installation, Manual
Carefully lift the fan and seat the downrod/hanger ball
assembly onto the mounting bracket that was just
attached to the outlet box. Be sure the groove in the
ball is lined up with tab on the mounting bracket.
WARNING:
Failure to seat tab in groove could cause
damage to electrical wires and possible shock or fire
hazard.
Slide downrod into the coupling on top of the motor.
Install the hanging pin by aligning the holes in the
coupling with holes in the downrod. Secure hanging
pin with locking pin. Securely tighten the two
previously loosened set screws.
Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2
inch from the end of each lead wire.
CAUTION:
All set screws must be checked and
retightened where necessary before installation.
4
5
Coupling screw
6 to 9 in
Hanger ball
Groove