10
Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.
NOTE:
When following this procedure from step1 to step 3, the filter system will be removed;
when following it from Step 3 to Step 1, the filter system will be installed.
WARNING!
It is dangerous to open the door when washing as hot water may scald you.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the Power switch button, and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
Switch off the dishwasher by pressing the
button.
Power
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing them from the appliance.
Open the dishwasher door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
Changing the Program during Use
Forgot to Add a Dish?
If you open the door
the machine will pause. The light indicator will
stop blinking and the buzzer will be
every minute until you close the door . After
you close the door, the machine will continue working after 10 seconds.
during a wash cycle
beeping
NOTE:
At the End of the Wash Cycle
A cycle that is underway can only be modified if it has been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see" Loading the Detergent " section).
Press the Start/Pause
b
utton
and the machine will be in standby state. Press the program button for more than
3
to change the program to the new desired cycle setting (see " Starting a wash cycle." section ).
1
2
seconds
A forgotten dish can be added any time before the detergent cup opens.
Add extra dishes.
Close the door
After the spray arms stop working,you can open the door
completely.
2
3
Open the door a little to stop the washing.
1
4
5
6
Press the Start/Pause button
Press the
button, the dishwasher will run
after 10 seconds.
Start/Pause
When you press the Start/Pause button to pause during washing, the running indicator will
stop blinking and the dishwasher will
every minute unless you press the
Start/Pause button to start.
be beeping
NOTE:
