13
for personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
FROM THE POWER CORD.
EARTHING
CONNECTION
n
n
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place. If the water pipes are new or have not been used for
an extended period of time, let the water run to make sure that the water is clear. This
precaution is needed to avoid the risk of the water inlet being blocked and damaging
the appliance.
Hot Water Connection
The water supply to the appliance can also be connected to the household hot water
line, such as central systems or heating systems, as long as it does not exceed a
temperature of 60 C. In this case, the wash cycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.The connection must be made to
the hot water line following the same procedures as described in the section for the
connection to the cold water line.
WARNING!
Improper connection of the equipment earth conductor can result in the risk of an electric
shock.
Check with a qualified electrician or service agent if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. if the plug does not fit properly into
the outlet, please have a qualified electrician to install a proper outlet.
n
n
n
Water Connection
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to
avoid kinking or squashing it. The top of the hose must be less than 1000mm high.
M
A
X 1
0
0
0
m
m
A
Counter
Front
Drain pipe
NOTE:
The top of the hose
must be less than
1000mm high.
¦40mm
B
PLEASE HANG THE DRAIN HOSE BY EITHER A, B
