Parmco HX-1-6S-4E, Инструкция по установке и эксплуатации

Страница: 12 / 12

9
Before inser ti ng the hob into the work surface, place the adhesive seal around the underside edge of the hob. It is important to fi x the seal
evenly without gaps, to prevent liquids from seeping underneath the hob.
1. Turn the hob upside down (ensure the surface will not damage the hob).
2. Place the gasket around the bo
tt om edge of the hob.
3. Screw one end of the fi xing brackets into the holes on the underside of the hob.
4. Place the hob into the work surface cutout, so it is si tti ng fi rmly on the surface.
5. Adjust the posi ti on of the brackets to suit the thickness of the work surface.
6. Screw the hob to the underside of the work surface using the other end of the fi xing brackets already a tt ached to the hob.
Notes:
• The hob must be installed by authorised, quali fi ed personnel only.
•
The hob should not be installed above cooling equipment, dishwashers or dryers.
•
All surfaces around the hob should be able to withstand the heat generated by the hob.
•
Do not use a silicon sealant to seal the appliance against the aperture. This will make it di ffi cult to remove the hob requires
servicing.
Do not over tighten the hob
clamps as distortion of the hob
may occur.
!