Parmco FS 600-CER, Инструкция по установке и эксплуатации

Страница: 24 / 29

23
•
Installation of this appliance and its connection to the electrical mains must only be
carried out by authorized personnel. Before any service procedure, it is important to
ensure that the appliance is DISCONNECTED from the electrical mains.
•
Do not modify this appliance.
•
After removing the appliance from the packaging, make sure it is undamaged. In the unlikely
event this occurs, contact Parmco before operating this appliance.
•
Make sure that this appliance is adequately ventilated.
• Ensure that the room is well ventilated by keeping the air intakes free of obstruction and in
good working order, and/or by installing a ventilation extraction system.
• If the appliance is used intensively for a long time, the effectiveness of the ventilation will need
to be increased, for example, by opening a window or increasing the power of the ventilation
fan.
NOTES TO THE AUTHORIZED INSTALLER
This appliance shall only be installed by an authorized person. This appliance shall only be installed
in complete accordance with the Gas and Electrical Standards of New Zealand. All local regulations,
building code requirements, and all other statutory requirements must be met.
Data Label
The data label is located at the rear of the appliance and inside of the utility draw if
fitted. A duplicate label is supplied for you to adhere to a suitable accessible area next
to the appliance. The data label on the appliance must NEVER be removed.
Ventilation
Make sure that this appliance is installed in accordance with the ventilation requirements.
Before any procedure, it is important to check that the appliance is DISCONNECTED from the
electrical mains. Parmco declines all responsibilities for any damage deriving from installations
that are in breach of the regulations in force or from failure to comply with these installation
instructions.
Combustible Surfaces
The appliance shall be installed in accordance with the New Zealand standards relating
to the installation of domestic cooking appliances.
In general, any adjoining wall surface within 200mm from the edge of any burner must be of a
suitable non-combustible material to a height of 150mm, for the entire length of the appliance.
Any combustible construction (e.g. cabinetry) must be a minimum of 750mm above this appliance.
If a combustible bench top is within 200mm of any burner, then the appliance top should be a
minimum of 10mm above the bench top. Any ventilation product supplied by Parmco Appliances
should be a minimum of 650mm above this appliance.
Installing Units on a Plinth
INSTALLATION INSTRUCTIONS