PARKZONE Ultra Micro F4U Corsair RTF/BNF, Инструкция по эксплуатации

Страница: 6 / 25

6
RTF
®
Binding is the process of programming the receiver of the control unit to recognize the GUID
(Globally Unique Identifi er) code of a single specifi c transmitter. You need to ‘bind’ your chosen
Spektrum
TM DSM® technology equipped aircraft transmitter to the receiver for proper operation.
Your F4U Corsair RTF transmitter
comes pre-bound to the aircraft,
so binding should not be
necessary. All that is needed to
begin fl ying is installation of fully
charged batteries in the aircraft
and transmitter.
Installing Transmitter Battery
3
4
1
2
6
5
Note: For a list of compatible DSM® transmitters, please visit www.bindnfl y.com.
Note: When using a Futaba transmitter with a Spektrum DSM module, you will need to
reverse the throttle channel.
Transmitter and Receiver Binding
EN

Binding Procedure Reference Table
1. Refer to your transmitter’s unique instructions for binding to a receiver.
2. Make sure the fl ight battery is disconnected from the airplane.
3. Power off the transmitter.
4. Connect the fl ight battery in the aircraft. The receiver LED will begin to
fl ash (typically after 5 seconds).
5. Put your transmitter into bind mode. If using the transmitter that is
supplied with the RTF version, push the left control stick vertically into
the case until it clicks, while powering on the transmitter.
6. Make sure transmitter controls are neutral and throttle is in low position.
7. After 5 to 10 seconds, the receiver status LED will become solid,
indicating that the receiver is bound to the transmitter.
Note: If the LED does not go to a solid light, refer to Troubleshooting
Guide at back of manual.
5
1 2 3
Lower throttle and throttle
trim to lowest settings.
Connect fl ight battery
and attach to hook and
loop strip.
Continuous LED
Power on
Transmitter
Wait 5
Seconds
Before Flight
6
CAUTION: Always keep hands away from propeller. When armed, the motor will turn the
propeller in response to any throttle movement.