PARKZONE T-28D Trojan BNF, Инструкция по эксплуатации

Страница: 4 / 12

5 6
Step 3 Step 4
Attaching the Wing
In order to attach the wing of your T-28D, please follow
these simple instructions:
1. Locate the included wing-securing screw.
2. Turn over the fuselage so you are looking at the
bottom. Do the same with the wing.
3. Connect the aileron leads to the pre-installed
Y-harness, noting proper orientation. Route the
Y-harness lead through the access hole in the bottom
of the fuselage.
4. Carefully align the two locator pins on the front of
the wing into the two small holes in the front of the
fuselage.
5. Slide the aileron leads inside the fuselage so that
they will not become pinched in between the wing
and the fuselage when securing the wing.
6. Slide the bottom of the leading edge of the wing into
the fuselage as shown, making certain it is perfectly
centered. This must be done correctly in order to
allow the screw to thread into the fuselage. Once you
are certain the wing is centered, tighten the screw to
secure the wing.
7. The wing is correctly installed when no gap exists
between the wing and fillet.
8. Gently pull up on the rear of the canopy hatch to
remove and set aside.
9. Plug the Y-harness lead into one of the AIL ports of
the Spektrum AR500 receiver.
Installing the Landing Gear
1. Install the main landing gear by inserting it into the
locator hole in the wing. Swivel the landing gear
toward the retaining clips and gently snap into place.
2. Insert the nose gear into the steering assembly
on the underside of the cowl with the flat spot
facing forward.
3. Align the retaining screw with the flat spot on the
cowl. The retaining screw should be visible through
the front of the cowl.
4. Using a Phillips screwdriver, tighten the retaining
screw. The retaining screw should be accessible
through the front of the cowl, however, you may
choose to remove the cowl for easier access.
5. Reposition the T-28D so that it is resting on the
landing gear.
3
4
6
2
4
1