EN
Landing Gear Installation
1. Install 2 tires (
A
) on the strut (
B
) using 2 wheel collars (
C
) and 2 set screws
(
D
). Tighten the set screws on the fl at spots of the strut.
Tip:
Threadlock may be required to keep the collar on the strut.
2. If desired for scale appearance, install the left and right fairings (
E
) (marked
L and R) on the respective sides of the strut.
3. Turn the latch (
F
) and open the battery hatch.
4. Install the strut in the channels (
G
) in the fuselage as shown.
5. Install the left and right strut brackets (
H
) (marked L and R) in the respec-
tive slots on the bottom of the fuselage using 4 screws (
I
).
6. Replace the battery hatch and turn the latch.
Disassemble in reverse order.
A
B
1.
2.
3.
4.
5.
6.
1. Install the horizontal tail (
A
) on the fuselage as shown.
2. Carefully insert the 2 pins of the vertical fi n (
B
) through the horizontal tail
holes and the fuselage holes. Turn the rudder so the control horn is under
the horizontal tail.
3. Under the fuselage, install the 2 screws (
C
) into the fuselage and the verti-
cal fi n pins. Tighten the screws, but do not break the plastic.
4. Install the rudder hinge screw (
D
) as shown. Tighten the screw, then loosen
it one half of a turn so the rudder turns freely.
5. Connect the respective clevises in the outermost holes in the rudder and
elevator control horns. Refer to the clevis adjustment instructions to center
the rudder and elevators.
When needed, disassemble in reverse order.
Clevis Installation
Tip:
Turn the clevis on the linkage to change the length of the linkage
between the servo arm and the control horn.
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired
hole in the control horn.
• Move the tube to hold the clevis on the control horn.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the clevises to center the control surfaces.
Tail Installation
D
A
B
C
D
E
G
F
H
2.5 X 10mm (4)
I
3 X 14mm (2)
C
2 X 8mm
I
Bag A
Bag B
Bag B
6
