EN
Problem
Possible Cause
Solution
Reduced fl ight time
Flight battery charge is low
Completely recharge fl ight battery
Flight battery damaged
Replace fl ight battery and follow fl ight battery instructions
Flight conditions may be too cold
Make sure battery is warm before use
Spoilers not fully retracted
Center throttle trim and adjust clevises on spoiler servo so spoiler fully
retracts
Aircraft will not Bind
(during binding) to
transmitter
Transmitter too near aircraft during binding process
Move powered transmitter a few feet from aircraft,
disconnect and reconnect fl ight battery to aircraft
Aircraft or transmitter is too close to large metal object,
wireless source or another transmitter
Move aircraft and transmitter to another location and attempt
binding again
The bind plug is not installed correctly in the bind port
Install bind plug in bind port and bind the aircraft to the transmitter
Flight battery/Transmitter battery charge is too low
Replace/recharge batteries
Bind switch or button not held long enough during bind
process
Power off transmitter and repeat bind process. Hold transmitter bind
button or switch until receiver is bound
Aircraft will not con-
nect (after binding)
to transmitter
Transmitter too near aircraft during connecting process
Move powered transmitter a few feet from aircraft, disconnect and
reconnect fl ight battery to aircraft
Aircraft or transmitter is too close to large metal object,
wireless source or another transmitter
Move aircraft and transmitter to another location and attempt
connecting again
Bind plug left installed in bind port
Rebind transmitter to the aircraft and remove the bind plug before
cycling power
Aircraft bound to different model memory (ModelMatch
TM
radios only)
Select correct model memory on transmitter
Flight battery/Transmitter battery charge is too low
Replace/recharge batteries
Transmitter may have been bound using different DSM
protocol
Bind aircraft to transmitter
Control surface does
not move
Control surface, control horn, linkage or servo damage
Replace or repair damaged parts and adjust controls
Wire damaged or connections loose
Do a check of wires and connections, connect or replace as needed
Transmitter is not bound correctly or the incorrect model
was selected
Re-bind or select correct model in transmitter
Flight battery charge is low
Fully recharge fl ight battery
Regulator damaged
Replace regulator
Controls reversed
Transmitter settings are reversed
Perform the Control Direction Test and adjust the controls on
transmitter appropriately
Troubleshooting Guide
16
