PARKZONE Ember, Инструкция по эксплуатации

Страница: 4 / 11

6 7
Step 4
Flight Control Test
Warning: Keep everything clear of the propeller before starting the
control test in the event that you accidentally turn on the motor.
1. Attach the main landing gear by sliding the gear into the lower
slot of the front wing mount.
2. Be certain that the throttle stick is down in the “Off” position.
3. Move the right stick from side to side. The rudder should move
per your transmitter input.
4. Move the right stick full forward. When this is done, the elevator
control surface should move down.
5. Pull the right stick back and the elevator control surface should
move upward.
6. If your airplane is not responding correctly to the transmitter
input, do not fly. Some correction is needed. Call the Horizon
Support Team at 1-877-504-0233.
7. When the test is complete, be sure to disconnect the flight
battery first, then turn off the transmitter. This should be done
each time you turn off the airplane.
Note:
It is very important to make sure that the control surfaces
(rudder and elevator) are at 0 degrees, or neutral, when the right
transmitter stick is centered.
Step 5
Reversing Flight Controls
Should the Ember’s electronic components be used in another
aircraft, you may find it necessary to reverse the operation of flight
control surfaces. Reversing the rudder and aileron operation can be
accomplished by following the steps below:
1. Be certain that the battery is unplugged from the aircraft and the
transmitter is turned off.
2. Push down on the digital trim button for the surface you would
like to reverse.
Top elevator trim button—elevator normal
Bottom elevator trim button—elevator reverse
Left rudder trim button—rudder normal
Right rudder trim button—rudder reverse
Shown with right stick pushed to the left. Shown with right stick pushed to the right.