parktool PRS-TT, Инструкции

Страница: 1 / 4

5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
PARK TOOL CO.
PRS-TT Tool Tray
Magnet Assembly
1. Loosely assemble the M6 x 16mm button head cap screw (#8), M6
washers (#9), and M6 T-Nuts (#4) onto the magnet bar (#7). (Figure 1)
2. With the Park Tool logo right side up slide the magnet bar with
hardware onto the side of the extrusion (#2) until magnet is flush with
end cap (#11) and fully tighten.
Hook Assembly
1. Remove one M8 nut from the hook (#6) and slide into the bottom
T-track of the extrusion. (Figure 2)
2. Thread the end of the hook into the M8 nut in the T-track so that the
other M8 nut and the washer are on the outside of the T-track, as
shown. Thread until just before the hook stops threading.
3. Slide the hook in the desired location and tighten the lower M8 nut
with a 13mm wrench.
PRS-TT
Instructions / Instructions / Anleitung / Instrucciones
STEP 5
STEP 2
2
3
4
5
1
8
9
11
3
2
13
7
4
2
6
2
15
10
14
12
10
16
13
17