Parkside PWSAP 20-Li B2, Инструкции по эксплуатации и безопасности, Страница: 49 / 174

48 GB/IE
m
CAUTION! HEALTH RISK!
u
Never work on materials containing
asbestos . Asbestos is considered
carcinogenic .
¾
Switching on: Push the rear part of the
on/off switch 3 down and slide it forward .
(Fig . K, 1&2) .
Continuous operation:
Tilt the front part
of the on/off switch 3 downwards until it
engages (Fig . K, 3) .
¾
Switching off: Press the rear part of the
on/off switch 3 so that it snaps back into its
off position .
˜
Trial run
NOTE
u
Always carry out a no-load trial run before
starting work and after every accessory
tool replacement . Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises .
˜
Working instructions
˜
Grinding
m
WARNING!
u
Never use a cutting wheel for grinding!
¾
Hold the product at a 10 to 15° angle for
easy handling and smooth grinding results .
¾
Apply the grinding wheel to the work surface
with a light, steady pressure for maximum
grinding efficiency . It should never be
necessary to force the product . The weight of
the product applies adequate pressure .
¾
Excessive pressure will overload the motor,
slow the grinding action, put dangerous
stress on the grinding wheel and causes
breakage .
¾
Move the product back and forth steadily .
˜
Wire brushing
m
WARNING!
u
Do not use a brush that is damaged,
or which is out of balance . Use of a
damaged brush could increase potential
for injury from contact with broken brush
wires .
¾
Avoid applying too much pressure which
causes over bending of wires, leading to
premature breakage .
¾
Work with moderate feed, suited to the
material being worked .
¾
Avoid bouncing and snagging the wire
brush, especially when working corners,
sharp edges etc . This can cause loss of
control and kick-back .
˜
Abrasive cutting
m
WARNING!
u
Never use grinding wheels for cutting!
When using a cutting wheel, the guard for
cutting must be used when operating the
power tool .