Parkside PWS 230 C3, Перевод оригинальной инструкции, Страница: 29 / 105

PWS 230 C3
GB
│
IE
│ 25 ■
Fitting the additional handle
CAUTION!
► For safety reasons, this appliance may only
be used with the additional handle .
Failure to do this can lead to serious injury.
The additional handle can be screwed
onto the left or the right depending on the job
at hand.
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when chang-
ing cutting/rough grinding discs.
Roughing and
cutting discs become very hot. Allow them to cool
down completely before touching them.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the whole must fit the
mounting flange without any play. Do not use a
reducer or adapter.
■ Check the roughing/cutting disc. It should not
be damaged or damp, and it should have no
cracks.
Otherwise, it could break during use
and cause injuries.
NOTE
► Use only discs which are free of dirt.
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■ RISK OF INJURY! Press the spindle locking
button only when the mounting spindle is
at a complete standstill.
♦ Press the spindle locking button to lock the
motor.
♦ Undo the clamping nut using the two-hole
mounting spanner (see fig B).
♦ Place the rough grinding or cutting disc with the
label side towards the appliance on the mount-
ing flange .
♦ Then replace the clamping nut with the raised
side facing up on the mounting spindle .
With thin grinding discs (see fig. 1):
♦ The collar of the clamping nut faces upwards
so that a thin grinding disc can be fitted safely.
12
≤ 3,2 mm
Fig. 1
♦ Press the spindle locking button to lock the
motor.
♦ Tighten the clamping nut using the two-hole
mounting spanner .
With thick grinding discs (see fig. 2):
> 3,2 mm
Fig. 2
The collar of the clamping nut faces upwards so
that the clamping nut can be fitted securely onto
the mounting spindle .
♦ Lock the mounting spindle .
♦ Tighten the clamping nut in a clockwise di-
rection using the two-hole mounting spanner .
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
♦ For safety's sake run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.