Parkside PWDA 20-Li C3, Перевод оригинальной инструкции по эксплуатации и безопасности

Страница: 23 / 100

21 GB
Nozzle Area of application
Housekeeping
nozzle
[ ]
o
Car seats
o
Cushions
o
Sofas
o
Matresses
Crevice nozzle
[ ]
o
Grooves
o
Joints
o
Sofas
o
Car seats
o
Confined spaces
˜
Using the handle
Fig. I
Handle
NOTE
u
The handle
[ ]
has a built-in air pressure
regulation function.
o
Decrease suction power: Slide the air
regulator
[ ]
in the opposite direction of the
mark.
o
Increase suction power:
Slide the air
regulator
[ ]
in the same direction of the
mark.
˜
Removing the container lid
NOTE
u
Remove the container lid
[ 4]
for installing
or replacing the filter bag and emptying the
metal container
[ 7]
.
Fig. M
1. Unlock the latches
[ 9]
by pulling them away
from the metal container
[ 7]
.
2. Lift up the latches
[ 9]
and disconnect them from
the rib
[ ]
.
3. Reverse above steps to lock the container
lid
[ 4]
on the metal container
[ 7]
.
Fig. N, O
1. Hold the carry handle
[ 1]
and remove the
container lid
[ 4]
from the metal container
[ 7]
.
2. The filter basket
[ ]
is exposed for filter
installation or replacement.
3. Fold down the carry handle
[ 1]
after use and
before storing the product.
˜
Installing the filter
m CAUTION!
u
Never vacuum without a filter installed to the
product. Sucked in substances may contain
metal or hard, sharp particles, which may
damage the motor or cause an electric
shock. Dust would be blown out from the
blow connector
[ ]
at a very high speed
which could cause serious personal injury.
u
Only vacuum liquids with the foam filter
[ ]
installed to the product. Otherwise the
product will be damaged. The paper filter
bag
[ ]
will also be damaged, if you use it
for wet vacuuming.
NOTE
u
The pleated filter
[ ]
and the paper filter
bag
[ ]
are suitable for dry vacuuming only.
u
Do not use the pleated filter
[ ]
for
vacuuming very fine dust or dirt (e.g.
sanding dust). The pleated filter can be used
for many other materials though.
Pleated filter
[ ]
(dry vacuuming)
Fig. P
NOTE
u
Before installing pleated filter, ensure the
lever
[ ]
is unlocked.
1. Turn the container lid
[ 4]
over.
2. Install the pleated filter
[ ]
to the filter
basket
[ ]
.
3. Insert the pleated filter
[ ]
until the bottom side
of the pleated filter touches the surface of the
filter basket
[ ]
.
4. Turn the lever
[ ]
to lock the pleated filter
[ ]
in place.
5. Pull the pleated filter
[ ]
slightly without
movement, to check if the pleated filter is
installed properly.