Parkside PWD 12 B2, Инструкции по эксплуатации и безопасности

Страница: 17 / 57

15 GB/IE/NI
˜
Before use
m
WARNING!
u
There is a risk of accident if the product is
operated using an electrical power supply
that does not match the specifications
shown on the rating label of the product .
u
The mains voltage and the frequency of
the power source must correspond with the
specifications on the product's rating plate .
m WARNING!
Switch off the product and disconnect
it from the mains before replacing
attachments, cleaning and when not
in use .
˜
Assembling the swivel castors
Fig . C
Turn the metal container
[ 8]
upside down, so
its bottom is facing upward .
Insert the metal shaft of the swivel castor
[ 10]
into the hole of the plastic holder until it stops .
Check if the swivel castor
[ 10]
can rotate
freely .
˜
Connecting/removing the
flexible hose
Vacuuming
Fig . D
Align the hose coupler
[ 16b]
of the flexible
hose
[ 16]
with the vacuum connector
[ 9]
.
Push the hose coupler
[ 16b]
slowly into the
vacuum connector
[ 9]
until the clip lock
[ 16a]
clicks into place .
Check if the flexible hose
[ 16]
is connected
properly by pulling the hose coupler
[ 16b]
slightly . If the hose coupler does not move, the
flexible hose is connected properly .
Check if the flexible hose
[ 16]
can be rotated
freely .
Removing: Press the clip lock
[ 16a]
down .
Pull the hose coupler
[ 16b]
out of the vacuum
connector
[ 9]
.
Blowing air
Fig . E
NOTE
u
This is an auxiliary function which can be
used to blow away dust or small objects .
Align the hose coupler
[ 16b]
of the flexible
hose
[ 16]
with the blow connector
[ 4]
.
Push the hose coupler
[ 16b]
slowly into the blow
connector
[ 4]
until the clip lock
[ 16a]
clicks into
place .
Check if the flexible hose
[ 16]
is installed
properly by pulling the hose coupler
[ 16b]
slightly . If the hose coupler does not move, the
flexible hose is connected properly .
Check if the flexible hose
[ 16]
can be rotated
freely .
Removing: Press the clip lock
[ 16a]
down .
Pull the hose coupler
[ 16b]
out of the blow
connector
[ 4]
.