Parkside PTSS 1200 C2, Перевод оригинальной инструкции

Страница: 14 / 46

PTSS 1200 C2 GB
│
IE
│
NI
│
CY
│
11 ■
Mitre angles up to 45°
♦ Apply the guide rail with the foam rubber
elements onto the workpiece.
♦ Place the appliance with the groove onto
the guide rail .
♦ Adjust the cutting angle as described.
♦ Hold the machine with both hands firmly on
the handles and .
♦ Switch on the appliance as described in
"Switching on and off". Place the appliance
with the front part of the base plate on the
workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Plunge cutting using the guide rail
♦ Apply the guide rail with the foam rubber
elements onto the workpiece.
♦ Place the appliance with the groove onto
the guide rail .
♦ Adjust the desired cutting depth as described
above.
♦ Place the rear edge (as far as possible) against
a stop.
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on
the handles and and pivot it.
NOTE
► The cutting width marking on the side of
the blade guard shows the front and rear
cutting point of a 165 mm saw blade at
maximum cutting depth. This applies both for
plunge cuts using the guide rail and
plunge cuts without using the guide rail .
Further applications are not permitted.
Cleaning and maintenance
WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work
on the appliance.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Use a soft, dry cloth to clean the housing.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
Disposal
The packaging is made from environ-
mentally friendly material and can be
disposed of at your local recycling
plant.
Do not dispose of power tools
in your normal domestic waste!
European Directive 2012/19/EU
requires that worn-out power tools are
collected separately and recycled in an environ-
mentally compatible manner.
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary. The packag-
ing material is labelled with abbreviations (a) and
numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites.
Your local community or municipal
authorities can provide information
on how to dispose of the worn-out
product.