Parkside PTSS 1200 C2, Перевод оригинальной инструкции

Страница: 12 / 46

PTSS 1200 C2 GB
│
IE
│
NI
│
CY
│
9 ■
Connecting the sawdust extractor
♦ If required, attach the chip ejector adapter for
dust extraction to the chip ejector .
♦ Connect an approved dust and chip extraction
device.
Checking blade guard functionality
NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
♦ Activate the safety lock-out and lower the
circular saw.
♦ Check whether the saw blade rubs against
the blade guard and whether it moves back to
its starting position automatically.
Use
Switching on and off
Switching on
♦ Push the safety lock-out upwards and hold it
in position.
♦ Press the ON/OFF switch . Once the saw is
running, you can release the safety lock-out .
Switching off
♦ Release the ON/OFF switch .
Setting the cutting depth
♦ Undo the screw for the cutting depth adjust-
ment and push the stop to the desired
cutting depth on the cutting depth scale :
–
without guide rail, see mark A.
–
with guide rail, see mark B.
♦ Retighten the screw for the cutting depth
adjustment
.
NOTE
► Adjust the cutting depth to the thickness of the
workpiece. The blade should not extend more
than one full tooth depth under the workpiece.
Setting the cutting angle
(mitre angle)
♦ Undo the two adjustment wheels for the cutting
angle .
♦ Tilt the motor to the desired cutting angle.
♦ Retighten the adjustment wheels .
NOTE
► If you have set the cutting angle adjustment to
0° or 45°, you can use the fine adjustment
screws and
8a
to make any fine adjust-
ment that you require.
Note the cut line
♦ Cut line markings
9a
of 0°/45° are imprinted
into the base plate .
♦ Align the appliance to the corresponding 0° or
45° cut line markings
9a
in accordance with
the set cutting angle.
♦ The inclined surfaces are reference points for this.
Connecting the guide rails
The guide rails will help you to make straight
cuts.
♦ To connect the 2 guide rails, push the
connector into the groove of the guide rails.
Tighten the grub screws using the supplied
hex key.
9a