Parkside PTSS 1200 C2, Перевод оригинальной инструкции

Страница: 39 / 60

PTSS 1200 C2 ■ 36 │
GB
│
MT
Before use
Fitting/changing the saw blade
Always remove the plug from the power socket
before working on the appliance.
NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
1. Activate the safety lock-out and push the
motor unit forwards a little way.
2. Open the clamping lever .
Then push the motor unit forward until you
hear the lock click into place. Release the safety
lock-out . The movement of the motor unit is
blocked upward and downward.
3. The clamping screw/washer
14a
is now located
in the cut-out
14 b
.
4. Press the spindle lock button (until it
engages) and use the hex key to release
the clamping screw/washer
14a
.
5. Remove the saw blade .
NOTE
► Ensure that the factory-fitted flange X stays
in place during installation and removal
(see fig. A).
Fig. A
6. To fit a saw blade , carry out the above steps
in reverse order.
WARNING!
► The direction of rotation of the saw blade
and the machine must match.
Connecting the sawdust extractor
♦ If required, attach the chip ejector adapter for
dust extraction to the chip ejector .
♦ Connect an approved dust and chip extraction
device.
Checking blade guard functionality
NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
♦ Activate the safety lock-out and lower the
circular saw.
♦ Check whether the saw blade rubs against
the blade guard and whether it moves back to
its starting position automatically.
Use
Switching on and off
Switching on
♦ Push the safety lock-out upwards and hold it
in position.
♦ Press the ON/OFF switch . Once the saw is
running, you can release the safety lock-out .
Switching off
♦ Release the ON/OFF switch .
X