Parkside PTSS 1200 C2, Перевод оригинальной инструкции

Страница: 40 / 60

PTSS 1200 C2
GB
│
MT
│ 37 ■
Setting the cutting depth
♦ Undo the screw for the cutting depth
adjustment and push the stop to the desired
cutting depth on the cutting depth scale :
–
without guide rail, see mark A.
–
with guide rail, see mark B.
♦ Retighten the screw for the cutting depth
adjustment
.
NOTE
► Adjust the cutting depth to the thickness of the
workpiece. The blade should not extend more
than one full tooth depth under the workpiece.
Setting the cutting angle
(mitre angle)
♦ Undo the two adjustment wheels for the cutting
angle .
♦ Tilt the motor to the desired cutting angle.
♦ Retighten the adjustment wheels .
NOTE
► If you have set the cutting angle adjustment to
0° or 45°, you can use the fine adjustment
screws and
8a
to make any fine adjust-
ment that you require.
Note the cut line
♦ Cut line markings
9a
of 0°/45° are imprinted
into the base plate .
♦ Align the appliance to the corresponding 0° or
45° cut line markings
9a
in accordance with
the set cutting angle.
♦ The inclined surfaces are reference points for this.
Connecting the guide rails
The guide rails will help you to make straight
cuts.
♦ To connect the 2 guide rails, push the
connector into the groove of the guide rails.
Tighten the grub screws using the supplied
hex key.
NOTE
► The guide rails have a splinter guard
(black rubber lip). The splinter guard must be
adjusted before making the first cut. Place the
guide rail onto a workpiece. Set a cutting
depth of approx. 10 mm. Switch the circular
saw on and push it gently and evenly in the
cutting direction.
9a