Parkside PTSG 140 D2, Перевод оригинальной инструкции

Страница: 25 / 118

25
GB
Switching on:
2. Press the power switch “ I ” (3), the de-
vice starts.
Switching off:
3. Press the off switch „ O “ (3), the device
turns off.
4. Next, remove the mains cable (4) from
the wall socket.
After switching on the device, wait until the
device has reached its max. speed. Only
then may you commence sanding.
Sanding
The arrow above the sanding disc
(1) indicates the direction of rotation of the
disc sanding device.
The sanding speed can be regulated using
the speed regulator (2).
Mounting horizontally (
A

):
• Place the workpiece on the sanding
table (8) and slowly bring it to the de-
sired angle
towards the left half of the
sanding disc (1).
Mounting vertically (
A

):
• Slowly bring the workpiece to the desired
angle towards the sanding disc (1).
Cleaning
Pull the mains plug before any ad-
justments, maintenance or repair.
Do not use any cleaning agents or
solvents. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
Have any work on the device
that is not described in this in-
struction guide performed by a
professional. Only use original
parts. Allow the device to cool
off before any maintenance or
cleaning is undertaken. There
is a risk of burning!
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
• Remove chips, dust and dirt, i.e. with a
brush.
Transport
Switch off the device and unplug
the mains plug.
Allow the device to
cool down.
Carry the device with two hands.
Maintenance
The device is maintenance free.
Always check the device before using it
for obvious defects such as loose, worn or
damaged parts, correct the positioning of
screws or other parts. Exchange the dam-
aged parts.
Storage
Store the appliance in a dry place well out
of reach of children.