Parkside PTB-16, Инструкции по эксплуатации и безопасности

Страница: 8 / 98

6 GB
PILLAR DRILL
The numbers in the following text
correspond to the numbers in the
illustrations.
Warning! Always read the
instructions for electrical products
carefully before use. This enables
you to become more familiar with
the product and avoid
unnecessary risks. Keep these
instructions in a safe place, where
they are always available.
1. EQUIPMENT
SPECIFICATIONS
Technical specifications
Rated voltage 230 V
Rated frequency 50 Hz
Rated input 500 W
Operation mode S2 30 min
Motor speed without load 385-2600/min
Number of speeds 9
Capacity drill chuck /
Spindle Nose Taper 16 mm/MT-2
Max. drilling depth 50 mm
Max. drilling capacity steel 16 mm
Weight 20.5 kg
L
pA
(Sound pressure level) 58 dB(A)
L
WA
(Sound-power level) 71 dB(A)
Vibration 1.34 m/s
2
The operation mode S2 30 min means
that you must allow the drill to cool down
to room temperature after 30 minutes of
continuous use.
Drill overview
Fig. A, B, C
1. Motor
2. Locking screws
3. Feed handle
4. Clamp lever
5. Baseplate
6. Column
7. Drilling table
8. Screw clamp
9. Chuck guard
10. Drilling depth display
11. On/Off switch
12. V-belt housing
13. V-belt pulley
14. Motor plate
15. Centring
16. Hexagonal screw
17. Adjusting screw
18. Fitting for chuck key
19. Ring
20. Wing nuts
21. Vice screws
Scope of supply
1 Pillar drill
1 Drill chuck
1 Chuck key
2 Allen key
3 Feed handle
3 Screws M8
3 Washers M8
1 Machine vice
2 Screws M10
4 Washers M10
2 Nuts M10
Before starting up please check whether
the supply is complete and/or has been
damaged during transport.
Your pillar drill has only been designed for
drilling metallic materials.
Equipment specifications