GB
9
1. Introduction
Important!
When using equipment, a few safety
precautions must be observed to avoid injuries
and damage. Please read the complete
operating manual with due care. Keep this
manual in a safe place, so that the information
is available at all times. If you give the
equipment to any other person, give them
these operating instructions as well.
We accept no liability for damage or accidents
which arise due to non-observance of these
instructions and the safety information.
2. Safety information
Ensure that you observe the following points in
order to avoid accidents and injuries.
Do not overload your swing arm.
Do not continue to use the swing arm if it is
damaged.
Ensure that all bolts are tightly fastened
and check them frequently for your own
safety.
Ensure that the cotter pin is properly
inserted through the bore holes.
Lifting and carrying persons with the cable
winch is strictly prohibited! Additionally,
persons may not loiter underneath the
cable winch/swing arm assembly.
Persons who are not aware of these safety
precautions may not use this product.
All components must be regularly checked for
any kind of deformation or damage.
Observe the maximum permissible load
capacity (see „Technical Data“)!
3. Layout and items supplied
(Fig. 1/2)
1
1. Cotter pin Ø 3 x 30
1
2. 5 x Hexagon nut M12
1
3. 5 x Spring washer Ø 12
1
4. 5 x Washer Ø 12
1
5. Hinge pin, large
1
6. 4 x Hexagon bolt M 12 x 60
1
7. Pipe collar for support arm
1
8. Cotter pin Ø 3 x 45
1
9. Pipe collar for rectangular boom
10. Support arm
11. Rectangular boom 45 x 45 x 1.8
12. Hexagon bolt M 12 x 70
13. 2 x Pads for clamping brackets
14. Hexagon nut M8
15. Spring washer Ø 8
16. Washer Ø 8
17. Extension pipe 40 x 40 x 2.5
18. Hexagon bolt M8 x 15
19. Hinge pin, small
20. Sleeve
4. Proper use
The swing arm is designed to be attached to a
cable winch. For this, the swing arm must be
mounted to a well fastened steel bar with a
diameter of 48 mm.
The machine is to be used only for its
prescribed purpose. Any other use is deemed
to be a case of misuse. The user / operator
and not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the machine is used in commercial,
trade or industrial businesses or for equivalent
purposes.
Anleitung_2255412:_ 10.06.2010 16:10 Uhr Seite 9
