Parkside PSBSAP 20-Li B2, Перевод оригинальной инструкции

Страница: 12 / 81

PSBSAP 20-Li B2
■
8
│
GB
│
CY
Inserting/removing the battery pack
Inserting the battery pack
♦ Set the rotation direction switch
7
to the middle
position (lock). Push the battery pack
e
into
the handle until it clicks into place.
Removing the battery pack
♦ Press the release button
r
and remove the
battery pack
e
.
Checking the battery charge level
♦ Press the battery charge level button
u
to
check the status of the battery. The status/
remaining charge will be shown on the battery
display LED
z
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Additional handle
NOTE
► For safety reasons, you should never use
this tool without the additional handle
1
attached.
♦ Loosen the strap on the additional handle
1
by turning it clockwise.
♦ Slide the mounting ring for the additional
handle
4
over the chuck
w
.
♦ Turn the additional handle
1
to the required
position.
♦ Afterwards, twist the additional handle
1
anticlockwise again to tighten it.
Depth stop
♦ Undo the screw on the depth stop
5
.
♦ Fit the depth stop
2
into the additional
handle
1
.
♦ Make sure that the teeth on the depth stop
3
point upwards and downwards.
♦ Pull the depth stop
2
out until the distance
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
♦ Tighten the screw on the depth stop
5
to
lock the depth stop
2
into place.
Changing tools
Your cordless impact drill driver has a fully auto-
matic spindle lock
.
When the motor is stopped, the power train is
locked so that the chuck
w
can be opened by
turning . After you have attached the desired
tool and tightened it by turning the chuck , you
can continue working. The spindle lock is released
automatically when the motor is started (by pressing
the ON/OFF switch
8
).
Torque selection/selecting the
operating mode
You can set the torque using the torque selection
ring
q
or by choosing between the drill setting
and the hammer drill setting .
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard
materials or removing screws.
♦ Select the drill setting for drilling work by adjusting
the torque selection ring to the position .
♦ Select the hammer drill setting for hammer drilling
work by adjusting the torque selection ring to
the position .