Parkside PMGS 12 C3, Перевод оригинальной инструкции

Страница: 12 / 32

PMGS 12 C3 GB
│
IE
│
CY
│
9 ■
Using an accessory tool with a mandrel :
NOTE
► Use the screwdriver side of the combination
key to undo and tighten the screw on the
mandrel .
♦ Insert the mandrel into the power tool as
described.
♦ Use the combination key to undo the screw
on the mandrel .
♦ Insert the desired accessory tool between the
two washers on the screw.
♦ Use the combination key to tighten the screw
on the mandrel .
Switching on and off/setting speed
range
Switching on/setting the speed range:
♦ Connect the plug to the mains adapter
by plugging it into the plugging device
(see fig. A).
♦ Connect the appliance to the power supply
by inserting the power plug into the socket.
♦ Push the ON/OFF switch to a position
between "5000" and "20000".
Switching off:
♦ Push the ON/OFF switch to the "OFF"
position.
Using the grip ring with LED light
♦ Hold down the spindle lock and screw the
tensioning nut anticlockwise off the thread.
♦ Release the spindle lock .
♦ Then screw the grip ring anticlockwise off
the thread.
♦ Screw the grip ring with LED clockwise onto
the screw thread.
♦ Hold down the spindle lock and screw the
tensioning nut clockwise onto the thread.
♦ Release the spindle lock .
♦ Move the ON/OFF switch of the LED light to
the position "I" to switch it on.
♦ Move the ON/OFF switch of the LED light to
the position "0" to switch it off again.
♦ Proceed in reverse order to replace the grip
ring .
Notes on material processing/tools/
speed range
■ Use the milling bits for working on steel and
iron at maximum speed.
■ Calculate the rotational speed range for work-
ing on zinc, zinc alloys, aluminium, copper and
lead by trying it out on test pieces.
■ Use a low rotational speed for work on plastics
and materials with a low melting point.
■ Use a high rotational speed for working on
wood.
■ Carry out cleaning, polishing and buffing work
in the middle range.
The following are recommendations only and not
binding. When carrying out practical work, carry
out your own tests to see which tool and which set-
tings are ideal for the material you are working on.
Setting a suitable rotational speed
Number on the
speed control Material
being worked
5000 Plastics and materials
with a low melting
point
9000 Stone, ceramics
13000 Soft wood, metal
17000 Hardwood
20000 Steel