Parkside PLP 100 A1, Инструкции по эксплуатации и безопасности

Страница: 13 / 61

13 GB
Switching off:
Release the ON / OFF switch
4
.
Pause: At least 48 seconds
CAUTION! Never heat up the device if it is not fitted with a sol-
dering tip.
ATTENTION! Never use in continuous operation mode. The flow
of electrical current controls the delivery of soldering heat. As soon
as the ON / OFF switch
4
is released, the delivery of soldering
heat drops. If the ON / OFF switch
4
is pressed again, the deliv-
ery of soldering heat rises. Pay particular attention to achieving an
even delivery of soldering heat to ensure the highest soldering quali-
ty. You can do this by not allowing the soldering tip
1
to become
excessively hot.
Note: The device has a soldering light
3
to illuminate the work-
ing area.
Q
Replacing a soldering tip
CAUTION! DANGER OF BURNS! Allow the device to
cool down before replacing a soldering tip.
Release the two union nuts
2
using the open spanner
9
.
Pull the soldering tip
1
or
7
out of the holder.
Insert another tip into the holder.
Tighten the two union nuts
2
using the open spanner
9
.
Use Safety advice / Use