Parkside PLBA 20-Li A1, Перевод оригинальной инструкции

Страница: 12 / 86

12
CY GB
assembling/dismantling
the blower pipe
Assembly
1. Press the locking button (2) and slide
the blower pipe (1) onto the connector
nozzle (12) on the motor housing (3)
until it locks into place.
2. Check that the blower pipe (1) is secu-
re by pulling on it.
Disassembly
1. Press the locking button (2) and pull
the blower pipe (1) from the connector
nozzle (12) on the motor housing (3).
Charging the battery
Ensure that the ambient tem-
perature does not exceed
40°C or fall below 4°C during
the charging process.
If warm, allow the battery to cool
before charging.
Do not expose the battery to direct
sunlight for long periods and do
not place it on a radiator (max.
50°C).
1. You may need to remove the battery
(9) from the device.
2. Slide the battery (9) onto the charger
(8) as far as it goes.
3. Plug the charger (8) into a socket.
4. Once charging is complete, disconnect
the charger (8) from the mains supply.
5. Remove the battery (9) from the
charger (8).
Remove/insert battery
1. To remove the battery (9) from the de
-
vice, press the release button (11) on
the battery (9) and pull the battery out.
2. To insert the battery (9), push the bat
-
tery (9) along the guide rail (6) into the
device. You will hear it click into place.
Only insert the battery once
the battery-operated tool is
fully ready for use.
Operation
Caution! Risk of injury!
Always wear appropriate
protective equipment and
work gloves while working
with the device. Prior to each
use, ensure that the device
is working correctly. Ensure
that the device has been
mounted properly.
Stop using the device if the
On/Off button is damaged.
Personal protective equip-
ment and a fully functional
device reduce the risk of inju-
ries and accidents.
Observe noise protection rules and
other local regulations.
Switching on and off
Before switching the device on,
make sure that it is not touching any
objects. Ensure secure positioning.
1. To
switch on, slide the on-off switch
(4) forwards.
2. To
switch off, pull the on-off switch
(4) towards you.