Parkside PFS 710, Руководство по эксплуатации и технике безопасности

Страница: 13 / 85

Advice about ways of working when sawing
· Always make sure the saw blade type and the blade speed and oscillation
settings are suitable for the workpiece.
· Narrow blades are best for tight curves.
· Before sawing, always check the workpiece for foreign bodies such
as nails, screws etc. and remove them.
· Do not allow the ventilation slots to become covered.
· Switch the tool on and only then bring it into contact with the workpiece.
· The shoe must always be set against the workpiece surface.
· Saw through the workpiece using even pressure and speed of progress.
· If the saw blade jams, switch off the tool immediately. Open the sawn
split in the workpiece slightly using a suitable tool and extract the saw
blade.
Flush sawing:
You can use the supplied universal saw blade or a flexible bimetal saw
blade to saw projecting workpieces (e.g. pipes) directly on the wall
(see Fig. C).
Follow these steps:
1. Place the saw blade directly on the wall surface.
2. Bend the blade by sideways pressure so that the shoe
comes up
against the wall.
3. Switch on the tool as described above and trim the workpiece using
constant sideways pressure.
Plunge sawing:
Plunge sawing can be used only in soft materials (such as wood etc.).
Follow these steps:
1. Place the sabre saw on the workpiece and switch it on
as described above. Ensure that the underside of the shoe is set
against the top of the workpiece.
2. Slowly plunge the saw blade into the workpiece.
3. As soon as you have reached the required depth of cut, bring the blade
into the vertical position and continue sawing along the cutting line.
4. Finally switch off the sabre saw and lift the blade from the workpiece.
Inserting / replacing saw blades
• Remove the mains plug from the socket before carrying out any tasks
on the tool!
• Protect yourself from being injured by sharp blades. Wear appropriate
protective gloves when fitting and testing the blade.
• Before replacing the blade, make sure that it is free of any cutting residue
(e.g. wood splinters).
If necessary, clean out the saw blade mounting recess with a thin
paintbrush or by compressed air.
1. Unscrew the hexagonal socket head screw using the supplied
hexagonal socket screw key.
2. Feed the saw blade between the plunger and the clamp plate .
Make sure that locating pin engages in the mounting hole in the saw
blade. The blade must not pull out.
3. Retighten the hexagonal socket head screw .
Check that the blade is securely fitted before using the saw again.
Safety / Operation
PARKSIDE GB 13
BA-Ident-No. PFS710-112003-1 21.01.2004 12:40 Uhr Seite 13