14 GB
Setting the speed by ON/OFF
switch (see fig. E)
NOTE
u
The ON/OFF switch has a variable speed
control .
u
You cannot change the speed setting
during continuous operation .
Press the ON/OFF switch 5 lightly for a low
speed .
Increase the pressure to increase the speed .
Speed pre-selection
(see fig. F)
The product can be preset to desired rotational
speed from level 1 to 6 for mixture of different
viscosity .
Set the desired speed using the speed control dial
7 .
NOTE
u
Always start from lowest speed setting,
level 1, then increase the pre-selected
speed until best mixing effect is achieved .
Working with the mixer
Dip the universal stirrer 4 into the material
you want to mix at a low speed .
Once the spiral 4a is completely immersed in
the material you can increase the speed .
During mixing, move the universal stirrer 4
through the mixing container and continue
mixing until the material is thoroughly mixed .
After use
1 . Switch the product off . Disconnect the product
from the mains and let it cool down .
2 . Check, clean and store the product as
described below .
Cleaning and care
m
WARNING!
Always switch the product off,
disconnect it from the mains and let the
product cool down before performing
inspection, maintenance and cleaning
work!
Cleaning
The product must always be kept clean, dry
and free from oil or grease . Remove debris
from it after each use and before storage .
Regular and proper cleaning will help ensure
safe use and prolong the life of the product .
Inspect the product before each use for worn
and damaged parts . Do not operate it if you
find broken and worn parts .
Never allow fluids to get into the product .
Clean the product with a dry cloth . Use a
brush for areas that are hard to reach .
In particular clean the air vents after every
use with a cloth and brush .
Remove stubborn dirt with high pressure air
(max . 3 bar) .
Remove the universal stirrer 4 from the
agitator shaft 3 (Fig . C, D) . Clean the
universal stirrer 4 with water .
