Parkside PFDS 33 B3, Инструкция по сборке, эксплуатации и безопасности

Страница: 38 / 109

38 GB/IE/NI
Assembly
Loosen the adjusting knob
27
and pivot it up-
wards (see Fig. E).
Turn the pressing roller unit
28
to the side (see
Fig. F).
Loosen the feed roller holder
30
by turning it
counterclockwise and remove it by pulling it
upwards (see Fig. G).
Check the top of the feed roller
29
to see if the
appropriate wire thickness is set. If necessary,
the feed roller must be turned around or replaced.
The welding wire supplied (Ø 0.9 mm) must be
used in the feed roller
29
with the next highest
wire thickness diameter of Ø 0.9 mm.
The wire must be in the upper notch!
Reattach the feed roller holder
30
and screw it
tightly. (clockwise)
Remove the burner nozzle
7
by rotating it
clockwise (see Fig. H).
Unscrew the welding nozzle
14
(see Fig. H).
Lead the cable assembly
13
away from the
welding unit in as straight a line as possible
(place it on the floor).
H
7
14
Remove the wire end from the coil edge (see
Fig. I).
Shorten the wire end using a wire cutter or side
cutter to remove the damaged/ bent wire (see
Fig. I).
Note: The wire must be kept taut the entire
time to prevent it from loosening and unrolling!