Parkside PFBS 160 B2, Оригинальное руководство пользователя

Страница: 11 / 214

PFBS 160 B2 ■ 8 │
GB
│
IE
d) Avoid putting your hand in the area in front
of or behind the rotating cutting disc.
When
you move the cutting disc away from your hand,
it is possible, in the event of a kickback, that the
power tool along with the rotating disc could be
thrown out directly towards you along with the
rotating disc.
e) If the cutting disc jams or you stop working,
switch the tool off and hold it steady until the
disc has completely stopped turning. Never
attempt to pull a rotating cutting disc out of a
cut. This could lead to a kickback.
Identify and
remove the cause of the jam.
f) Do not switch the power tool back on for as
long as it is in the workpiece. Allow the
cutting disc to reach its full speed before you
carefully continue the cut.
Otherwise, the disc
may jam, jump out of the workpiece or cause
kickback.
g) Support panels or large workpieces to
reduce the risk of the cutting disc jamming
and causing a kickback.
Large workpieces can
bend under their own weight. The workpiece
must be supported on both sides, namely in the
vicinity of the cut, and also at the edge.
h) Be particularly careful when making plunge
cuts into existing walls or other obscured
areas.
The inserted cutting disc may cut into
gas or water pipes, electrical wiring or other
objects that can cause kickback.
Supplementary safety instructions
for working with wire brushes
Special safety instructions for working with
wire brushes
a) Be aware that the wire brush loses wire bris-
tles even during normal operation. Do not
overstress the wires by applying excessive
pressure to the brush.
The wire bristles can
easily penetrate light clothing and/or skin.
b) Allow the brush to run at working speed for
at least one minute before applying it to the
workpiece. Ensure that no one is standing in
front of or in line with the brush during this
time.
Loose pieces of wire could fly off during
the run-in period.
c) Aim the rotating steel brush away from your-
self.
When working with these brushes, small
particles and minute pieces of wire can fly off
at great speed and pierce skin.
Safety instructions for LED lights
CAUTION! THERE IS A RISK
OF INJURY TO THE EYES!
■ Never aim the light directly at people or
animals and never look directly into the light
beam of the LED light.
General safety instructions for
batteries and cells
■ Do not expose batteries or cells to heat or open
flames. Avoid storage in direct sunlight.
■ Cells or batteries must not be short-circuited. Cells
or batteries may not be stored dangerously in a
box or draw where they can short-circuit each
other or be short-circuited by other conductive
materials.
■ Do not unpack a cell or battery until you plan to
use it.
■ Cells or batteries must not be exposed to
mechanical impacts.
■ If a cell is leaking, do not let the fluid come into
contact with skin or eyes. If there is contact,
wash the affected area with plenty of water and
seek medical assistance.
■ Do not use any other charger apart from the
one specifically designed for use with these
appliances.
■ Always observe the polarity markings – positive
(+) and negative (−) on the cells, batteries and
appliances. Ensure proper use.
■ Cells or batteries, that are not suitable for use
with the appliance may not be used.
■ Do not use combinations of batteries from
different manufacturers, capacities, sizes or
designs.
■ Keep cells and batteries out of the reach of
children.
■ If a cell or battery is swallowed, seek medical
assistance immediately.