Parkside PFBS 12 A1, Руководство пользователя

Страница: 13 / 66

PFBS 12 A1 ■ 10 │
GB
│
CY
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the ON/OFF switch to the "OFF"
position.
♦ Insert the battery pack into the appliance
until it clicks into place.
Removing the battery pack:
♦ Press the two battery release buttons on
the side of the appliance at the same time and
remove the battery pack .
Checking the battery charge level
If the appliance is switched on, the status/remain-
ing charge will be shown on the battery LED 2 as
follows:
RED / ORANGE / GREEN = maximum charge
RED / ORANGE = medium charge
RED = low charge – charge the battery
Changing/inserting the tool/collet
chuck
♦ Press the spindle lock and hold it down.
♦ Turn the tensioning nut until the lock clicks
into place.
♦ Undo the tensioning nut from the thread
using the combination spanner .
♦ Remove any tool which is inserted.
♦ First push the intended tool through the tensioning
nut before inserting it into the appropriate
collet chuck for the tool shaft.
♦ Press the spindle lock and hold it down.
♦ Push the collet chuck into the thread insert
and screw the tensioning nut tight with the
combination spanner .
NOTE
► Use the screwdriver side of the combination
spanner to undo and tighten the screw on
the mandrel .
Switching on and off/setting speed
range
Switching on/setting the speed range:
♦ Set the ON/OFF switch with the speed control
to a position between "1" and "MAX".
Switching off:
♦ Set the ON/OFF switch with the speed control
to the "OFF" position .
Notes on working with materials/
tools/speed range
■ Use the milling bits for working on steel and
iron at maximum speed.
■ Determine the rotational speed range for working
on zinc, zinc alloys, aluminium, copper and lead
by trying it out on test pieces.
■ Use a low rotational speed for work on plastics
and materials with a low melting point.
■ Use a high rotational speed for working on
wood.
■ Carry out cleaning, polishing and buffing work
in the medium speed range.
The following are recommendations only and not
binding. When carrying out practical work, carry
out your own tests to see which tool and which
settings are ideal for the material you are working
on.