Parkside PESG 120 B3, Сборка, эксплуатация и инструкции по безопасности, перевод оригинальных инструкций.

Страница: 26 / 101

26 GB/IE
Safety instructions / Assembling the welding shield / Preparing to weld Safety instructions
the welding cables around the
body. Consolidate welding cables.
Safety notices specific to
the welding shield
Using a hot light source (e.g.
lighter) always check the weld-
ing shield is working properly
before starting to weld.
Welding splashes can damage
the glass shield. Replace dam-
aged or scratched glass shields
immediately.
Promptly replace damaged or
heavily soiled / splashed compo-
nents.
The equipment may only be op-
erated by persons who have
turned 16.
Familiarise yourself with the
safety instructions for welding.
Also refer to the safety instruc-
tions of your welding equipment.
Always use the welding shield
when welding. Failure to use the
shield may result in serious inju-
ries to the retina.
Always wear protective clothing
when welding.
Never use the welding shield
without protective glass, as the
optics can otherwise be dam-
aged.
Replace the protective glass
early to ensure good visibility
and fatigue-proof working.
Tight and moist spaces
When working in tight, moist or
hot spaces, use insulating pads
and intermediate layers in addi-
tion to gauntlet gloves made
from leather or other insulating
materials to insulate the body
from earth.
When using welding equipment
in electrically dangerous condi-
tions, e.g. in tight spaces from
conductive walls (kettles, pipes,
etc.), in wet spaces (soaking of
work clothes), the output voltages
of the welding equipment may
not be higher than 48 Volts (rms
value) in open loop. Based on
the output voltage this welding
equipment may be used in these
conditions.
Protective clothing
Whilst working the welder must
be protected against rays and