Parkside PDT 40 C2, Руководство по эксплуатации

Страница: 8 / 46

8 GB/CY
Preparing the product for use / Operation Safety of the fastener driving tool / Preparing the product for use
Use suitable personal protection equip-
ment, e.g. hearing and eye protection.
Wearing personal protective devices such as
dust mask, non-slip safety shoes, safety helmet
or hearing protectors, depending on the type
of fastener driving tool and its application, re-
duces the risk of injuries.
Additional safety information
for compressed air tackers
RISK OF INJURY!
Never
exceed the maximum permissible operating
pressure of 8 bar. Use a pressure reducer to
adjust the operating pressure.
RISK OF INJURY!
Never
use oxygen or other flammable gases as ener-
gy source.
Keep your working area clean and
well lit.
Untidy or poorly lit working areas
can lead to accidents.
Keep children and other individuals
away from the fastener driving tool
during use.
Distractions can cause you to
lose control of the device.
Remain alert at all times, watch what
you are doing and always proceed with
caution when working with a fastener
driving tool. Do not use any fastener
driving tool if you are tired or under the
influence of drugs, alcohol or medication.
One moment of carelessness when using the fas-
tener driving tool may result in serious injuries.
Avoid placing your body in an unnat-
ural position. Keep proper footing
and balance at all times.
By doing this you
will be in a better position to control the fas-
tener driving tool in unforeseen circumstances.
Before any repair and maintenance work or
transport, remove the device from the com-
pressed air source.
RISK OF INJURY! Do not use the device on
scaffolds or ladders.
Never use hydrogen, oxygen, carbon dioxide
or other bottled gasses to power this tool as
doing so may result in an explosion and thus
may cause severe injuries.
RISK OF INJURY!
Do not use the device if
the trigger lock
8
is damaged or has been
removed. Otherwise injuries may result.
When loosening the hose coupling, hold the
hose firmly in your hand to prevent injuries
caused by a rebounding hose.
Be absolutely certain to use a ¼‘„ threaded
nipple and a quick-release coupling for the
compressed air connection.
Never place your hands near the mouth when
the device is ready to operate. Otherwise inju-
ries may result.
Pay attention to damage.
Check the de-
vice for damage before bringing it into use. If
the device exhibits defects, it must not be oper-
ated under any circumstances.
Do not use any pointed objects.
Never
insert pointed and / or metal objects into the
inside of the device.
Original accessories / tools
Use only the accessories and attachments
detailed in the operating instructions.
The use of fasteners or other accessories other
than those recommended in the operating in-
structions could lead to you suffering an injury.
Preparing the product for use
NOTE:
always wear the protective goggles sup-
plied before putting the tool into operation. Remove
the protective film from the protective goggles before
using for the first time.
Connecting the compressed
air source
NOTE: The compressed air tacker must only be
operated with cleaned, oil-misted compressed air
and must not exceed the maximum operating pres-
sure of 8 bar. The compressor must be fitted with a
pressure reducer in order to regulate the operating
pressure.