Parkside PDS 30 A1, Руководство по эксплуатации

Страница: 7 / 36

■ 4 │
GB
│
IE
│
NI
PDS 30 A1
Parts and operating components
(See fold-out page for illustrations)
The ceiling prop PDS 30 A1 consists of the following parts:
▯ Rubber pad
1
▯ Upper bar
2
▯ Pump lever
3
▯ Lower bar
4
▯ Locking screw
5
▯ Tube
6
▯ Locking bolt
7
▯ Locking lever
8
Usage
♦ Loosen the locking screw
5
(Fig. A).
♦ If necessary, press the two locking bolts
7
out of their detent (Fig. B) and
pull the lower bar
4
out up to the required height until the rubber pad
1
is located under the load to be supported (Fig. C).
♦ Allow the two locking bolts
7
to engage completely in the tube
6
detent.
Use the red line which marks the position of the locking bolts
7
(Fig. D)
on the lower bar
4
as an orientation aid.
♦ If the length of the lower bar
4
is insufficient, push the locking lever
8
upwards (Fig. E) and pull the upper bar
2
out to the required height.
♦ Re-tighten the locking screw
5
(Fig. F).
♦ To make fine adjustments to the height, press the pump lever
3
several times
until the rubber pad
1
is located firmly under the load to be supported
(Fig. G).
♦ To loosen and remove the prop, press the locking lever
8
upwards until the
upper bar
2
has been completely retracted (Fig. H).
♦ Loosen the locking screw
5
(Fig. A).
♦ Hold the tube
6
firmly with one hand and press the engaged locking bolts
7
out of their detent (Fig. B).
♦ Push the lower bar
4
back inside completely.
IB_353782_PDS30A1_LB6.indb 4 21.01.2021 15:10:56