11
GB
16. Troubleshooting
WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault
Possible cause
Remedy
Saw blade without pins
loosens after switching off
the engine
Saw blade clamping screw (28/29) not tightened
enough
Tighten the saw blade clamping screw (28/29)
Motor does not start
Failure mains fuse
Check the mains fuse.
Extension cable defect
Change extension cable.
Fine-wire fuse defective
Check the fine-wire fuse and, if necessary, replace it with
a fine-wire fuse of the same type.
Connections on the motor or switch defect
Have it checked by an electrician.
Motor or switch defect
Have it checked by an electrician.
Saw blades brake
Tension set incorrectly
Set correct tension
Load too high
Feed workpiece more slowly
Incorrect saw blade type
Use correct saw blades
Workpiece not fed straightly
Avoid lateral pressure
Saw blade oscillates, not
aligned straightly.
Holders not aligned
Open the screws that fasten the holders. Bring the hold-
ers into the vertical position and tighten the screws again.
Содержание PDS 120 B2
