Parkside PDEXS 150 A1, Инструкции по эксплуатации и безопасности

Страница: 11 / 78

11 GB
Additional safety instructions
for pneumatic machinery
Compressed air can result in serious
injuries.
Always close the air supply, release pressure
from the hose, and disconnect the machine from
the compressed air supply, when the machine
is not in use, before switching accessories or
when performing repairs.
Never aim the air flow at yourself or
others.
Hoses flapping about can result in
serious injuries. Therefore, always inspect
hoses and their fasteners for damage and a
secure fit.
If using universal swivel couplings (coupling
discs) always use locking pins. Whip-check
hose safety cables must be used for protection
in the event the connection between the hose
and the machine or in between hoses fails.
Ensure not to exceed the maximum
pressure specified on the machine.
Never carry pneumatic tools by the
hose.
Original accessories / tools
Use only the accessories detailed in the
operating instructions.
The use of inserted
tools or accessories other than those recom-
mended in the operating instructions could lead
to you suffering an injury.
Before use
Selecting the grinding disc
Metal Removal and Surface:
The rate of metal removal and the surface quality
are determined by the grain size of the grinding disc.
lease note that corresponding grinding discs
with different grain sizes should be used for
processing different materials.
Changing sanding sheets
The air sander is fitted with a hook and loop fastening,
which allows for quick and easy replacement of
sanding discs.
Lift the grinding disc at the side and pull it off
from the backing pad
6
in order to remove it.
Note: Before securing a new sanding sheet, re-
move all dust and dirt from the sander plate
6
.
Ensure that the openings in the sanding sheet
concur with the boreholes of the sanding plate
6
.
Dust / swarf removal by suction
Please note the “Safety instructions” section.
Using the internal vacuum extraction
with dust collection device (see Fig. B):
Push the exhaust air hose
9
fully on to the
connection for dust extraction
2
. Put the open-
ing of the dust bag
10
over the free end of the
exhaust air hose
9
and fasten the dust bag
10
firmly in position.
Note: Empty the dust bag
10
in good time and
regularly to ensure optimum dust extraction. To
do this open the zip fastener on the underside
of the dust bag
10
.
Topping up the oil
In order for the air sander to have a long service life,
there must always be enough pneumatic oil in the
device.
You may ensure this in any of the
following ways:
Connect a service unit with an oiler to the
compressor.
Install a line oiler in the compressed air line or
at the compressed air device.
Put approx. 3–5 drops of pneumatic oil by
hand into the plug nipple
3
every 15 minutes
of operation.
Safety instructions / Before use Safety instructions