Parkside PBSG 95 D5, Инструкции по эксплуатации и безопасности

Страница: 19 / 73

19 GB/IE
otherwise indicated in this instruction
manual.
Have defective switches replaced by an
authorized service centre.
Do not use the tool if the switch does
not turn it on and off.
21. WARNING!
The use of any accessory or attachment
other than one recommended in this in-
struction manual may present a risk of
personal injury.
22. Have your tool repaired by a
qualified person
This electric tool complies with the rele-
vant safety rules. Repairs should only
be carried out by qualified persons us-
ing original spare parts, otherwise this
may result in considerable danger to
the user.
Before use
Note: Remove all packaging material from
the product.
The operator should stand in front and
stay close to the power tool to prevent
overreach.
In case of blockage, switch off the ap-
pliance and unplug from the mains.
Then clear the jam.
Initial use
Grinding drills
Note: First rough grind severely damaged
drills with a grinding block.
Fully lower the brick. To do so, turn the
dial
1
all the way in the DOWN ▼
direction.
Insert the drill into the smallest drill guide
11
on the sharpener it will fit. Please
refer to the markings (3 to 13) for the
exact sizes (Ø) of the respective drill
guides
11
.
Set the ON/OFF switch
4
to position
„I“ to switch on the product.
Turn the dial
1
in the UP ▲ direction
until you hear a grinding noise.
Note: The dial
1
controls the position
of the brick inside the grinding head, thus
the grinding pressure the brick applies
to the drill. The more the dial
1
is turned
in the UP ▲ direction, the greater the
grinding pressure. Be sure not to raise
the brick too high. The brick may other-
wise get in contact with the housing.
Loosely and quickly rotate the drill back
and forth about 10 times between the left
and right stop, applying light pressure
(small drills about 5 times).
Slightly pull out the drill, turn 180°
around its own axis and reinsert up to
the brick.
If necessary, repeat the entire process
until both faces are sharp. Polish so the
angle ( ) between the two cutting
edges (b) is 118°. Both cutting edges
(b) must have the same angle to the
drilling axle (a) and have the same
length for the drill to run centred (see
images below).