Parkside PBH 1500 F6, Оригинальное руководство пользователя

Страница: 10 / 17

10
Chuck suitable for use with
SDS+ system
• Slide the tool (chisel / drill) 17 into the tool
holder 10 .
• Turn the tool, if necessary in the tool holder
until it audibly clicks into place.
• Check the locking mechanism by gently
pulling the inserted tool.
• To remove the tool, pull the locking sleeve
back as far as it goes and pull the tool out of
the tool holder from the front.
Mounting the depth stop (Fig. D)
• Press and hold the depth stop locking latch 12
on the additional handle 9 .
• Insert the depth stop 15 into the hexagonal
opening provided on the additional handle
above the locking latch.
• Push the depth stop in the direction of the
hammer drill till the desired depth is reached.
• Release the locking latch of the depth stop.
• Check the locking mechanism by gently
pulling the inserted depth stop.
• To readjust the depth stop or to remove it,
proceed in same order.
5. Usage
Mains connection
The hammer drill is designed for use with single-
phase AC 230 V ~ / 50 Hz and has protective
insulation. Check whether the mains voltage of
the socket corresponds with the mains voltage
indicated on the drill’s rating label. Use an
extension cable if the work area is not close to
the mains outlet. Ensure an extension cable with
sufficient conductor diameter (min. 1.5 mm²) is
used. If necessary, ask the dealer for advice when
purchasing. The extension cable used should be
as short as possible. Ensure the mains cable does
not pose a tripping hazard.
Mains cables may only be replaced by the
manufacturer, an authorised service centre or a
qualified person.
Switching on and off (Fig. E)
Switching on:
• Press the On/Off switch 2 .
Switching off:
• Release the On/ Off switch.
Speed adjustment (Fig. F)
• The speed can be adjusted using the speed
regulator 6 according to the requirements.
This can be done when the machine is being
operated, with 1 being the lowest and 6 being
the highest speed.
The hammer drill is intended for use only in places
that have a continuous current rating of ≥ 100 A
per phase and are supplied with a rated voltage
of 230 V by the distribution network. If necessary,
please consult your electricity supplier to ensure
that the continuous current rating of the network
is adequate for connecting the hammer drill at the
point where it is connected to the power supply
network.
LED display
The hammer drill is provided with an LED status
indicator at the bottom of the vibration-proof
handle 5 .
The two LEDs indicate the following status:
- If the power cord is inserted, the GREEN LED
indicator starts to glow 7 . The hammer drill is
ready for use
- If the carbon brushes are qorn out, the RED
LED indicator starts to glow 8 . Stop the work
and contact the manufacturer‘s customer
service department.