40 GB/MT
Start-up / Maintenance and Cleaning / Service / Warranty
Start-up
Depth stop
Open the wing screw
1
.
Insert the depth stop
11
in the additional
handle
7
.
Make sure that the toothing on the depth stop
11
is pointing downwards.
Pull the depth stop
11
out as far as necessary
so that the distance between the tip of the drill
and the tip of the depth stop corresponds to
the desired drilling depth.
Firmly tighten the wing screw
1
.
Inserting / removing tools
Inserting tools:
Lightly grease the tool holder
8
before insert-
ing the tool.
To insert, pull back the locking sleeve
10
and
insert the tool.
Release the locking sleeve
10
. This locks the
tool holder. Pull the tool to ensure that it is firm-
ly locked in place. The tool has some radial play
inherent in the system.
Removing tools:
To remove the tool pull back on the locking
sleeve
10
.
Quick-release chuck for
round shaft drills
Do not use the quick-release
chuck for round shaft drills for hammer drilling or
chiseling applications!
Set the function selector switch
6
to the drill
symbol .
Attaching the quick-release chuck for
round shaft drills:
To attach the additional chuck for round shaft
drills (also see Fig. A) pull back the locking
sleeve
10
and insert the additional chuck.
Release the locking sleeve
10
. This locks the tool
holder. Pull the tool to ensure that it is firmly
locked in place.
Removing the quick-release chuck for
round-shaft drills:
To remove the additional chuck pull back the lock-
ing sleeve
10
and remove the additional chuck.
Inserting tools:
RISK OF INJURY!
Switch the
device off and unplug from the mains socket before
performing any work on the device.
Setting the function with the
function selector switch
Press and hold the release button for the function
selector switch
6 a
and turn the function selector
switch
6
until the desired symbol locks in next
to the arrow.
The functions are marked as follows:
Function
Symbol
Drilling / screwing
Hammer drilling
Chiseling
Chisel position
adjustment
Adjusting the chisel position:
This function allows you to turn the tool to the nec-
essary position for chiseling (also see Fig. C, D).
Turn the function selector switch
6
to position
.
Turn the tool inside the tool holder
8
to the
necessary position.
To chisel, turn the function selector switch
6
to .
